Build Your Own

Building a large storage shed is the same as building a small storage shed except it takes more materials and a heck of a lot more labor. Cut 26 boards to the height you want at the back of the shed, typically 6 feet (1.8 m); this equals 6 boards for the back wall and 10 for each of the sides. After you have cut out the first stringer you need to test it by setting it up against the shed wall and checking the cuts to see if they lay flat on the ground and against the shed wall.
To compensate for the structural loss in the wall, installing a header immediately above the top of the door will help bear the weight of the roof. There you can cut the panel to fit and lap over the other panel to complete the wrap of the building. For the sides, cut 4 boards that are 192 inches (490 cm) long.

For a basic, four wall building, two of the walls should be the whole length of your building. Typically a large building will have six inch by six inch pressure treated timbers for the base. Good woodworking plans will guide you through the complete project, starting with a complete list of materials and tools that you will need right down to the type of wood you should use.
They provide a solid flat base upon which to build or set a shed and evenly support the floor. Cut 2x4s to fit inside the lines and toe-screw them to the plywood to hold them in place while you fill in the center studs and nail on the siding. When you wrap it all around the building, your building will shed rain and you are ready to drive in the tractor.

Lean to sheds can be built against the side of an existing building or can be free standing. Although you can build a shed on a concrete slab, the majority refer to this site for additional information - the advantage, of storage sheds are built on skid foundations. I poured concrete corner pads to hold up my building. Good for prefab or home built sheds.
The first consideration when building a shed is deciding upon the location. Sheds don't need very strong foundations; a simple layer of concrete would do. But if the ground is prone to be frozen in winter, then the concrete foundation must be thinner. If you are planning on a larger shed, workshop or perhaps even an office, you may well require permanent foundations that extend underground a considerable distance.

Push it up so it's even with the top of the rafter boards, then nail them into the ends of the rafters. Many people consider pre-built sheds or shed-building construction plans, when building a shed. Use a nail gun to drive a nail in every 1 to 2 feet (0.30 to 0.61 m) to join the boards.

Level the ground (if necessary) and install deck piers along a grid to support the shed. There may be times when permits are not required, possibly for small buildings such as wood storage sheds. Shed ramps are built by running boards on edge from the shed wall under the door, down to the ground.